AVS Discussions
  Go Down

Negatron II build thread

ellisr63

  • *****
  • 520
  • Living the retired life in San Miguel de Allende
Re: Negatron II build thread
« Reply #30 on: September 17, 2018, 04:41:59 PM »
Finally have some progress...
1: fiber HDMI cable is on the way
2: 5 50wpc amps on the way
3: amp kit cases on the way
4: 4 small horn waveguides on the way,
5: When we get back from Europe I will have 4 DIY Klipsch Belle bass bins ready to go.
6: last few pieces for the rack shelves are at the powder painter now.

We are awaiting an estimate for my wooden trough/acoustic panel holders to be installed above the windows and on the other 3 walls.
Yamaha CX-A5100, 4 Klipsch RP150Ms, 4 Klipsch RP160Ms, 2 Yamaha P2500s, PS3, XBoxOne, Monoprice speaker wire, and XLR cables, 2 Furman filters, Pro-ProJect RPM 1.3 Carbon Turntable, Darbee Darcet,Samsung 65" 4k fp

ellisr63

  • *****
  • 520
  • Living the retired life in San Miguel de Allende
Re: Negatron II build thread
« Reply #31 on: September 25, 2018, 02:27:57 PM »
Today I worked on finishing up the new rack...when I found one board had a huge crack in it. I glued it, and clamped it, and will install it tomorrow. I also found a much nicer way to make the boards clear the bolts holding the shelves...I used a router so it is totally hidden from the top. This looks 100% better than using a jigsaw! All that will be left after tomorrow on the rack will be a stone Cantera top to match the stone in the right side of the picture. If I can I will start on my new pie shaped amp modules before we go on vaction...If not then they will get done at the same time as the new bass bins. I hope to have enough cash to get 2 Dirac boxes too by this Xmas...as they will also be my crossovers.
Yamaha CX-A5100, 4 Klipsch RP150Ms, 4 Klipsch RP160Ms, 2 Yamaha P2500s, PS3, XBoxOne, Monoprice speaker wire, and XLR cables, 2 Furman filters, Pro-ProJect RPM 1.3 Carbon Turntable, Darbee Darcet,Samsung 65" 4k fp

AVSMike

  • *****
  • 1531
Re: Negatron II build thread
« Reply #32 on: September 27, 2018, 07:12:28 AM »
My Baffle Wall System: https://discuss.avscience.com/index.php?topic=124.msg902#msg902

Mike Garrett
AV Science Sales
585-671-2968
mike@avscience.com

JVC, Sony, Epson, Marantz, Denon, Yamaha, Stewart, Seymour, Screen Innovations, Screen Excellence, DNP, Da-Lite, Triad, SVS, Martin Logan & more.

ellisr63

  • *****
  • 520
  • Living the retired life in San Miguel de Allende
Re: Negatron II build thread
« Reply #33 on: September 27, 2018, 07:48:14 AM »
Thanks Mike, my angles will be for a Atmos/Auro3d...on the Auro3d site they have the angles for a Atmos/Auro3d setup.
Yamaha CX-A5100, 4 Klipsch RP150Ms, 4 Klipsch RP160Ms, 2 Yamaha P2500s, PS3, XBoxOne, Monoprice speaker wire, and XLR cables, 2 Furman filters, Pro-ProJect RPM 1.3 Carbon Turntable, Darbee Darcet,Samsung 65" 4k fp

ellisr63

  • *****
  • 520
  • Living the retired life in San Miguel de Allende
Re: Negatron II build thread
« Reply #34 on: July 17, 2019, 09:52:11 PM »
Update... I just ordered 4 Klipsch rp160m speakers in cherry. These will be used as my front channels until my k402s are ready...once the fronts are ready these will be used as my surrounds, and surround back speakers.For the time being I will use my 4 channel Yamaha Pro amp for powering them until I get the B&O AMP modules installed in their case. Hopefully I will have 7 channels plus 4 Atmos channels by November. Next year will be projector, screen, and new AVP time.
Yamaha CX-A5100, 4 Klipsch RP150Ms, 4 Klipsch RP160Ms, 2 Yamaha P2500s, PS3, XBoxOne, Monoprice speaker wire, and XLR cables, 2 Furman filters, Pro-ProJect RPM 1.3 Carbon Turntable, Darbee Darcet,Samsung 65" 4k fp

  Go Up