AVS Discussions

Projectors => Premium Projectors => Topic started by: Rjhawk on February 19, 2017, 11:23:20 PM

Title: Help with remote JVC RS500
Post by: Rjhawk on February 19, 2017, 11:23:20 PM: Looking for some help and was not able to find an answer with search. I have a new (1 month old) RS500 and all of a sudden I'm having trouble with the remote. It sends a signal to the projector and the projector "blinks" a couple of times but does not respond. The controls on the ack of the projector work but that is really not practical.

I have tried shutting down and unplugging the projector and removing the hdmi cables for 5 minutes and new batteries in the remote. Is there a reset procedure or re-synch procedure I'm not aware of. Any suggestions will be appreciated.
Title: Re: Help with remote JVC RS500
Post by: AVSCraig on February 20, 2017, 11:59:13 AM: Quote from: Rjhawk on February 19, 2017, 11:23:20 PM
Looking for some help and was not able to find an answer with search. I have a new (1 month old) RS500 and all of a sudden I'm having trouble with the remote. It sends a signal to the projector and the projector "blinks" a couple of times but does not respond. The controls on the ack of the projector work but that is really not practical.

I have tried shutting down and unplugging the projector and removing the hdmi cables for 5 minutes and new batteries in the remote. Is there a reset procedure or re-synch procedure I'm not aware of. Any suggestions will be appreciated.

Call JVC customer service. Maybe your remote is bad. They will help !
Title: Re: Help with remote JVC RS500
Post by: AVSMike on February 22, 2017, 12:12:04 PM: Quote from: Rjhawk on February 19, 2017, 11:23:20 PM
Looking for some help and was not able to find an answer with search. I have a new (1 month old) RS500 and all of a sudden I'm having trouble with the remote. It sends a signal to the projector and the projector "blinks" a couple of times but does not respond. The controls on the ack of the projector work but that is really not practical.

I have tried shutting down and unplugging the projector and removing the hdmi cables for 5 minutes and new batteries in the remote. Is there a reset procedure or re-synch procedure I'm not aware of. Any suggestions will be appreciated.

Switch it over to setting "B" and see if that solves your problem.
Title: Re: Help with remote JVC RS500
Post by: Bob4K on February 22, 2017, 02:01:35 PM: Quote from: AVSMike on February 22, 2017, 12:12:04 PM
Switch it over to setting "B" and see if that solves your problem.
Or use the buttons on the rear of the PJ to go through the menus, and check that you did not switch the PJ to "B" by mistake.
If you did, switch it back to "A".